Durable design – the shell of the unit is made from anodised aluminium. The most exposed sides are strengthened so that the unit cannot be damaged
by flying stones etcc. The unit is dust and waterproof.

The display – the unit uses a segment display with 4 large main digits for showing the data, but also includes one 5th smaller digit for showing the trip with 100th resolution. Help icons are for clear detection of what source your trip is based on, or what mode you are seeing. This display is developed for using and reading under direct sunlight, but also contains yellow LED backlighting for use in dark stages.

Built-in buttons – you can control this unit from both sides (left or right), because it contains 3 buttons on each side (the same layout as on aftermarket remote buttons). This feature is helpful when you use your tripmaster too close to each other. For easy switching between modes, there is a dedicated centre button for one-finger control. The up and down buttons are for setting the trip and
many other functions.

Cable compatibility – you’ll find 4 cables on the back side for connecting the power, remote buttons, GNSS receiver and wheel sensor. All cables have durable insulation and M8 connectors and are compatible with aftermarket remote buttons, wheel sensors, or powering devices.

GNSS external receiver – GNSS is a professional-grade receiver with one metre-level accuracy and supports concurrent reception of four GNSS systems. The high number of visible satellites enables the receiver to select the best signals. This maximises the positional accuracy, in particular under challenging conditions such as in rally stages. The possibility of mounting the receiver on the top of a rally tower or roof maximises the signal receiving strength. The cable length is 0.5m. If you need a longer cable, you can use an M8 4-pin cable extension.